View Full Version : harness line initial instalment
22nd April 2007, 03:03 AM
hey, i am having a lot of trouble putting my harness lines on. I can't seem to get the front off of the boom... Is that how you do it?
22nd April 2007, 12:10 PM
I guess you could take thefront end off your boom, but normally removing the back end is much easier and requires no tools.
Unscrewing the retaining screws on the front of your boom could cause things to loosen up, or become misaligned, so that's probaby not a good way to put on your harness lines.
The back end of your boom should simply slide out (after you release the locks) and then you can "open up" the loops that go over the boom on your harness lines and silde them over the lock collars on the rear of the boom arms.
Then spread the boom arms or the tail piece a bit and reinsert the tailpiece tubes into the boom arms, readjust to the correct length and you have your harness lines installed.
Hope this helps,
vBulletin® v3.8.6, Copyright ©2000-2016, Jelsoft Enterprises Ltd.