PDA

View Full Version : damage of finish


rob jurriens
22nd September 2007, 01:28 AM
Hello

Due to an impact of a sharp object (hidden stone?) a bit of the white skin/finish on the rail of my iSonic has been damaged ('broken off'). Can this be repaired and how?

Roger
22nd September 2007, 06:16 AM
Hi Rob,
If it's just the paint/colorcoat that's damaged, get a spray can of white epoxy enamel paint that matches the white of your board (Here's a link, but it does not list the Pantone of the white used on your board)
http://www.star-board.com/2008/pages/products/asst_color.php

Mask off the damaged area and sand it slightly to remove anything loose. Give it a couple of light coats of paint and then lightly sand it back for a nice looking repair.
If your damaged area is greater, check out the "Damage Repair" pages at this link:
http://www.star-board.com/2008/pages/products/asst_repair.php
Hope this helps,