View Full Version : phantom320
17th September 2009, 07:27 AM
I've been playing the phantom 320 with a overdrive 8.5m sail and i found out i have problems jibing. The board takes a long time to repond to a turn??. Any advise or tips??.. Thxs
17th September 2009, 11:25 AM
Is the centerboard up or down when you are trying to do your jibes?
If you have the center board in the down/deployed position, the board has a hard time turning around both the centerboard and the rear fin.
Try your jibes with the centerboard up (stowed inside the board).
The alternative is to learn a "sink jibe" where you move back far enough so the nose comes up pretty high and you can pivot the board around the rear fin with much less effect from the centerboard.
Also, you need to really "tip" your 8.5 m2 rig well over the side of the board to drive the board around the jibe.
The more you rake the rig out to the side, the faster your board will turn.
Hope this helps,
17th September 2009, 10:57 PM
Roger makes good points. Assuming you are talking about non planing jibes, jibing any board with a centerboard is challenging if you want to get around quicker. As the wind picks up, it becomes even more difficult.
Regardless, the "sink jibe" / "pivot jibe" is the way to go. The challenging part is that the rail on the outside of the turn (port jibe - starboard side of board) will drop and the port side will lift. This is more pronounced on narrow boards (old long boards), but it still happens a little on the wide boards.
The quickness of the jibe depends on how much you sink the tail (how far back you move). You have to bare off the wind a bit (30-45 degrees off a beam reach) before you begin your sink jibe. If you don't, the board won't turn downwind, but will instead head upwind.
Once the board begins to jibe, be ready to move quickly to keep from being tossed off. Pivot jibes can be very fast and you don't lose any gained windward advantage, you just turn on a "dime".
The same jibe can be accomplished without the daggerboard and may be a little easier because the outside rail will not drop as much as it does with the daggerboard down.
Once you figure it out, they are pretty easy to do.
30th March 2010, 04:34 PM
Thank you so much for your post.
vBulletin® v3.8.6, Copyright ©2000-2015, Jelsoft Enterprises Ltd.