|20th September 2007 12:37 AM|
|Unregistered||I have, fitted better than the 2 drake fins supplied with the iS133, no sanding whatsoever|
|19th September 2007 04:56 PM|
....never bought a Select fin that fitted first time!
I have always had to sand them down quite a lot.
|19th September 2007 03:21 PM|
|30th August 2007 07:14 AM|
The Rubber mallet has worked for me . Some of my customers have thought they needed to sand the fins l supplied because they were so tight. l am saying that chinook boxes are a good standard size, and other brand boxes may varie. Maybe l haven't come across a brand of fin that is way out, even select fins fit. Just try a gentle tap and see if things give. These are wave boards though.
You will learn more from questions than insults.
|29th August 2007 11:15 PM|
|Unregistered||No, the mullet gets in the way|
|29th August 2007 09:48 PM|
Are you sure you don't just use yer head
|29th August 2007 09:24 PM|
l build boards for a living and give the fin a whack with a rubber mallet.All fin brands have fitted so far in chinook boxes.
|29th August 2007 07:03 PM|
Sanding your finhead... there was an intresting story in the dutch surfmagazine about that (written by some very fast guys)
It was about this (till it fits) :
1) start with the width of your finhead
2) make the top of your finhead bit round (like tectonics)
3) (if is still doesnt fit) sand the backside of your finhead till it fits properly.
I have seen people go very fast with a fin that wasnt very tight in the finbox...
I have seen people go very fast with a fin to deep in the finbox...
I have seen people with fins that where so tight in the box that the hard foam around the box damaged
I have seen people that need about 20 min for fitting fin properly (every time)
There is some middle in sanding where the fin will fit most boards (99%). THat is for me:
bit tight in my Carbon Art boards. (I once forgot the screws and did 65kmh/36kn and fin was still in finbox)
bit less tight in my Starboard Isonic 2006
|29th August 2007 06:55 PM|
Unable to use fin
Well I guess the fact that a pair of select fins I purchased before going to Weymouth last year were so far off that after a hour of sanding I still couldn't use them (I only noticed the poor fit at the event) and so I stuck with the stock fins.
The simple fact is that they should fit and you shouldn't have to sand a whole lot. I understand that a little bit of sanding being required isn't a bad thing, ensures a perfect fit, but the requirement of an electric sander and lots of time seems excessive???
|29th August 2007 06:26 PM|
|This thread has more than 10 replies. Click here to review the whole thread.|