|20th November 2013 05:54 PM|
I would use 200g/mē carbon and 100 or 160g/mē twill glass, because that is what i have in the garage. It dosent matter, as long as you sand properly, so the new laminate has good contact with the old laminate. Use strong tape and perhaps peel-ply to create pressure. best would be with vaccum pump , but not necessary for such a small damage.
Beware of epoxy! use double latex gloves when you use it, never breathe the sanding dust.
|20th November 2013 11:08 AM|
Thanks a lot for your tips, kapten k!
I asked for a refund and if that doesn't work out I have to fix it (compensation or not). I just wanted to comfirm the weights of the carbon and glass cloth. I could get:
80g/mē Unidirectional Carbonfabric HP-U080/50C:
and 86g/mē Glass filament fabric Silane Twill HP-T80E:
I could not find 60g glass. Doe it even matter, if the cloths weight won't match 100%? I mean could I also use Biax Carbon 150?
The rocker looks ok and intact. I looked at it with a straight ruler and the bending of the shape/rocker looks the same as on the other side.
|19th November 2013 09:02 PM|
sand it down, and repair the sandwich with PU-glue, if the bottom laminate is broken, it will be more work!
I would use a 6cm wide carbon strip and a10cm wide glass strip put the glas on top of the carbon, so its easier to sand out smooth,
The rail looks ok, since most of the strength is there.
If the guy who sold it to you knew about the damage and said nothing, i would demand a refund or compensation!
Check the bottom, rocker( with a long straight ruler) and check for water!
|19th November 2013 02:20 PM|
How to repair crack on iSonic 2011
Last week I bought a used 2011 iSonic. I checked the board for damages and wether it has got soft or not. All looked ok, but then 2 days later I noticed a crack! I feel really stupid now, because it is quite obvious:
I stood on the left and right side of the crack and it seems to me, that it is just the top layer of the sandwich, which got apart. The weight with footstraps is around 6.6-6.7kg, so I assume there is no water inside.
I read that the 2011 models use UD Carbon 80 and 60g glass. How would you fix that? Do I have to take off/grind off about 5 cm on each side of the crack and then laminate 1 or 2 layers of 60g glass fiber (10cm wide) on top of it? I read that it should not be stronger after the fix to avoid hard spots.
So basically I just want to ask how you would fix that.
Thanks a lot and greetings,