Go Back   Starboard Forums > Free Forum > US Select Fin > Kode fin Box

Thread: US Select Fin > Kode fin Box Reply to Thread
Your Username: Click here to log in
Image Verification
Post Icons
You may choose an icon for your message from the following list:

Additional Options
Miscellaneous Options

Topic Review (Newest First)
3rd April 2009 08:55 AM
Unregistered Thanks...

After taking Stephen's advice above I now have the fin fitting quite nicely. It's firm but easy enough to remove.
2nd April 2009 09:07 PM
Screamer I always had issues with Select fins (which I like btw).That goes for both tuttle slalom fins and US box. A lot of their bases seem to have a "bulge" they're not uniformly thick. Sending took care of the problem (but be carefull not to overdo it, my fsw fin now sits a mm or two too deep in my Kombat). It should be snug fit rather than loose.
2nd April 2009 08:38 AM
PrydeMan I use a small corner sander to sand he fin down. You will need to sand and try a few times until the fin fits flush. Also you need to sand off the fin box edges to avoid the fin box flaking away.

2nd April 2009 06:43 AM
US Select Fin > Kode fin Box

Hi all,

I recently purchased a Select fin (US) for my Kode86. But I have run into a problem with the fit - the base of the fin is probably 1/4-1/2 a mm too thick for the box. I've carefully tried sanding away some of the thickness of the fin base but cant seem to get a snug but not overly tight fit. Another issue is the base of the fin just wont sit flush with the bottom of the board.... it protrudes by a mm or 2. The Drake fin which came with the board fits perfectly. I guess my question is, has anyone else experienced this with Select fins and if so how was it fixed?


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT +7. The time now is 06:08 PM.