Go Back   Starboard Forums > Free Forum > 30 knots ... and always spin out

Thread: 30 knots ... and always spin out Reply to Thread
Your Username: Click here to log in
Image Verification
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Additional Options
Miscellaneous Options

Topic Review (Newest First)
18th September 2009 01:34 AM
docgr Interesting Ian
i've used actually a very negative outhaul .... Adjustable while sailing ... Saturday I'll
try a little flat sail .. But i didn't feel too much pression against my back hand

thanks

Giorgio
17th September 2009 05:55 PM
Ian Fox Hi Georgio,

As Remi had commented, this can be many factors, some well outside our visibility or control; one more to consider; outhaul/draft stability in the rig. No, it's not to deflect "blame" from fin etc, but as the speed builds up, the sail loads increase due to apparent wind loads (this can vary a little according to sailing angle, but consider you hold the same line/angle to wind) - under increased load the sail draft tends to move backwards (even in best sails - yes, but better ones move later and less) - to combat that you sheet harder with back hand - to offset backhand pull you (even unknowingly) counter by extra push on your back foot - and there comes your magic 30 kt spinout eachtime.

Typically a lot of guys use a "more powerful" negative (or non positive) outhaul in the attempt to get more power for more speed, which up to a point is correct, but the ideal sail trim for acceleration can often not be ideal for top end.

Very easy to test/try and see if this helps. You might be suprised, it's a common thing.

Cheers ~ Ian
17th September 2009 03:16 PM
Remi Hi Giorgo,

Personally I am over 30, but basicly minimum as long as your under arm.

All the best
17th September 2009 12:12 AM
docgr Thanks!

Harness line are adjustable (my fault) max is 28" ... enough?

All the best

Giorgio
16th September 2009 12:54 PM
Remi Hi Giorgo,

For the footstraps, try all in the back for the back one and in the middle for the front one.
Boom height should be around eyes height and harness line adjustable and need to be more longer.
Fin can be a problem, please sand all your Drake fin with 600 gr until you take off the Drake sign.

Hope this help.

All the best
14th September 2009 05:38 PM
docgr Hi Remi

(I've posted the same message in the Ask our team ... didn't find a way to cancel this one ... )

Anyway

I-sonic 86

Boom height : with the 6.2 NP rs slalom between 1/2 and 1/3 of the sail hole
Harness line lenght : 26"
Footstraps position : both external ... front holes for the back straps, rear holes for the front strap
Mast base position : 1 cm forward of the center


Thanks!

Giorgio
14th September 2009 06:17 AM
Remi Hi Giorgo,

This can come from many things, from you or from your trim, so please let us know this :

Boom height :
Harness line lenght :
Footstraps position :
Mast base position :

All the best
13th September 2009 10:43 PM
docgr
30 knots ... and always spin out

Hi everyone,

I-sonic 111 with a 7.1 Point7 AC0 - 38 Drake fin
I-sonic 86 with a 6.2 NP RS slalom - 32 Drake fin

Tried several times, but every time i approach 30 knots always ... always spin out (29,77 spinout ... 29,50 ... and so) both with te 111 and this morning with good wind and the 86.

Ok, I'm going to buy SL4 fins ... but ... is there something else about the trimming that I can do? .. Seems so strange to get 28 ... 29 ... apparently without problem and then .... ooops the board always start sliding ...

Quite a newbe i speed matters .. of course

Thanks for any advice

Giorgio

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT +7. The time now is 01:42 AM.