|25th June 2012 02:18 PM|
|Unregistered||BIG thanks for the reliable answer, I as the engineer slightly was confused by starboard marketing with types of fin box.|
|25th June 2012 07:05 AM|
Yes, there should be no strength or failure issues with using a 50 cm std. Tuttle fin in your
deep Tuttle fin box.
You will need 2ea. 20mm longer fin screws to reach down to the barrel nuts (brass threaded
slugs) that are pressed into the fin.
The normal change over from std. Tuttle to Deep Tuttle fins normally occurs right around 60 cm.
Using a 60 cm + fin in a std. Tuttle box begins to introduce a risk of fin box failure unless the fin
is fitted to the box very carefully.
Hope this helps,
|25th June 2012 04:44 AM|
Tuttle Drake 50 in Deep Tuttle fin box of iSonic 127
sail - rs slalom 10.0
Can I use this configuration with a maximum capacity without risk of damage of the fin box
|25th January 2011 10:37 PM|
|mark h||Yep, you can|
|25th January 2011 09:15 PM|
Can I use Deep Tuttle' and Tuttle' for iSonic 117?