damage of finish
Due to an impact of a sharp object (hidden stone?) a bit of the white skin/finish on the rail of my iSonic has been damaged ('broken off'). Can this be repaired and how?
If it's just the paint/colorcoat that's damaged, get a spray can of white epoxy enamel paint that matches the white of your board (Here's a link, but it does not list the Pantone of the white used on your board)
Mask off the damaged area and sand it slightly to remove anything loose. Give it a couple of light coats of paint and then lightly sand it back for a nice looking repair.
If your damaged area is greater, check out the "Damage Repair" pages at this link:
Hope this helps,
|All times are GMT +7. The time now is 04:15 PM.|
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.