Starboard Forums

Starboard Forums (http://www.star-board-windsurfing.com/forum/index.php)
-   Windsurfing School (http://www.star-board-windsurfing.com/forum/forumdisplay.php?f=11)
-   -   Failed non-skid Formula 159 (http://www.star-board-windsurfing.com/forum/showthread.php?t=963)

djw1 13th January 2007 02:54 AM

Failed non-skid Formula 159
 
After two seasons in Florida sun, the non-skid on my Formula 159
turned white and flaked off.
leaving the deck impossibly slick.
Any ideas on how to renew the non-skid
without a lot of weight and without covering the wood.

Jack USA 8811

Russell 14th January 2007 02:40 PM

RE: Failed non-skid Formula 159
 
Hi Jack.

You can buy non slip powder we get it from a local foberglass swimming pool manufacturer. you then buy 2 component car lacquer.

You must take off all the old non slip and then either spray or use a roller to put the car lacquer on and then use a sive to sprincle the powder on.


Roger 14th January 2007 09:56 PM

RE: Failed non-skid Formula 159
 
Hi Jack,
If you want to do the repair of the non-skid yourself, Russell has it pretty much right.
I've asked Eva Holliman from the http://www.boardlady.com/
site to post something adressing your questions.
If she does not give us an answer, I'm sure she will respond back to me with a list of materials you need.
Mostly, as Russell suggests, you need some "non slip powder" (specially ground "acrylic dust" or "Deck Dust" made up specifically for non-skidding fiberglass or composite surfaces) and some sort of a binder or resin to stick the dust to the wood surface of your board.
You will need to carefully sand off any of the remaining original non-skid, then let your board "bleach a bit in the sun.
When it's been restored to it's "original golden patina" by the sun, you are ready to apply a thin layer of "binder" (clear linear polyurethane or some other thinned resin) and then use a regular kitchen sifter to lightly spread a layer of the acrylic dust on.in the binder before it drys.
Since you are in Florida, you may be able to take your board to someone like Randy Nordlund (Fort Myers area) and have the non-skid redone professionally.
Productsw like "ReDeck" work OK, but they seem to add alot of weight
and may not stick as well as a properly prepared surface with clear LP and acrylic dust.
Hope this helps,

djw1 17th January 2007 11:59 PM

RE: Failed non-skid Formula 159
 
Russell, Roger

Thanks guys for the help.

Jack


All times are GMT +7. The time now is 07:13 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.