View Single Post
Old 7th August 2007, 01:54 AM   #8
Roger
Dream Team - School Guru
 
Join Date: Aug 2006
Posts: 2,112
Default RE: Help Harness lines

Hi Steve,
Way back when, when I still lived out in Calif. I wrote to the Reactor bar guys about the sharp edges where the strap gets cut/chafed, and recommended that they run aradius cutter around the slots on both sides, plus I recommended a conversion coating under the paint to slow down the corrosion. This was about the time they converted to powder coating, and my subsequent DaKine Reactor bars seem to last a whole lot longer. I did once replace the roller with the new "kit" that Reactor put out with a new screw, a new axle, and 3 different roller shapes.
R
Roger is offline   Reply With Quote