Thread: Shrinking boxes
View Single Post
Old 29th August 2007, 06:26 PM   #10
Join Date: Sep 2006
Posts: 88

Originally Posted by Unregistered View Post
I have had the same problem with Tectonic fins as well as Vector fins,all needed sanding to fit into my boards.The same goes for friends who have purchased these fins.
Recently I had to sand down a Tectonic fin to fit a Naish board. It's no big deal, though. I was a bit frightened that I took too much off with the disk sander on the electric drill, but it fits quite well in the box now. I can't see why you guys find this important.
WSguy is offline   Reply With Quote