Starboard Forums - View Single Post - Help

Hugh Jarmes · 17th October 2006, 03:10 AM

Can anyone help?

I discovered yesterday (after a week end racing) that the rubber 'O' ring had perished completely on the board vent plug of my SB Formula 160.

I don't know how long it has been like that but the board had taken in some water - not a lot but enough to be "wicked" up when I pushed a rolled up paper towel in. It may have only been in there for a short time but it also might have been accumulating over a longer period.

I've continued with this "wicking" and have put the board in a warm room. I've also turned the board over regularly. Has anyone else had a similar experience?

Has much damage been done? Can it be undone? and if so how?

Does anyone have any suggestions? Thanks

17th October 2006, 03:10 AM	#1
Hugh Jarmes Member Join Date: Oct 2006 Posts: 38	Help - Water in the hole! Can anyone help? I discovered yesterday (after a week end racing) that the rubber 'O' ring had perished completely on the board vent plug of my SB Formula 160. I don't know how long it has been like that but the board had taken in some water - not a lot but enough to be "wicked" up when I pushed a rolled up paper towel in. It may have only been in there for a short time but it also might have been accumulating over a longer period. I've continued with this "wicking" and have put the board in a warm room. I've also turned the board over regularly. Has anyone else had a similar experience? Has much damage been done? Can it be undone? and if so how? Does anyone have any suggestions? Thanks