View Single Post
Old 15th November 2008, 08:33 PM   #3
pierrec45
Member
 
Join Date: Sep 2007
Location: Sydney
Posts: 81
Default Planing versus end speed

I guess the original question was about minimal planing speed, but Chemical you're right to point out the diff.

I see people aiming solely at minimal planing speed, just to be disappointed with the other 95% utilisation of the board, which is planing+xx knots.

(And/or getting bored with planing at those minimal speeds after a while...)
pierrec45 is offline   Reply With Quote