Starboard Forums - View Single Post

sauls · 18th February 2009, 07:04 AM

A couple of clarifications.

The 0.7086 higher than a std tuttle, is that measured perpendicular to the root of the fin or perpendicular to the top surface?

radius on the corners between the sides and the front/back edges?

Any idea on the proper drilling for the barrel nuts or will that depend on whether you're using std or metric?

I can't seem to get the Deep Tuttle dimension from the back to the first bolt hole to work out (you said 0.491, I get 0.514). Are the holes in a different location than the std Tuttle box?

Thanks for the Great Reply Roger!!

Saul

18th February 2009, 07:04 AM	#5
sauls New Member Join Date: Oct 2008 Posts: 9	A couple of clarifications. The 0.7086 higher than a std tuttle, is that measured perpendicular to the root of the fin or perpendicular to the top surface? radius on the corners between the sides and the front/back edges? Any idea on the proper drilling for the barrel nuts or will that depend on whether you're using std or metric? I can't seem to get the Deep Tuttle dimension from the back to the first bolt hole to work out (you said 0.491, I get 0.514). Are the holes in a different location than the std Tuttle box? Thanks for the Great Reply Roger!! Saul