View Single Post
Old 2nd April 2009, 06:43 AM   #1
Unregistered
Guest
 
Posts: n/a
Default US Select Fin > Kode fin Box

Hi all,

I recently purchased a Select fin (US) for my Kode86. But I have run into a problem with the fit - the base of the fin is probably 1/4-1/2 a mm too thick for the box. I've carefully tried sanding away some of the thickness of the fin base but cant seem to get a snug but not overly tight fit. Another issue is the base of the fin just wont sit flush with the bottom of the board.... it protrudes by a mm or 2. The Drake fin which came with the board fits perfectly. I guess my question is, has anyone else experienced this with Select fins and if so how was it fixed?

Regards
Evan
  Reply With Quote