View Single Post
Old 14th August 2009, 03:00 PM   #14
bigblue
New Member
 
Join Date: Jan 2008
Location: Sweden
Posts: 15
Default

Thanks Roger. I got the job done, but once in place i could not tighten the front because the bolt in the fin was not correctly thread. And in addition i noticed a small indentation in the back of the fin base. About 1 cm wide and 2 mm deep. It was as if there was not enogh material during the making. So I''m taking the fin back to the shop for replacement.
bigblue is offline   Reply With Quote