View Single Post
Old 16th February 2010, 09:41 PM   #1
Lanee
Member
 
Join Date: Jan 2010
Posts: 20
Default Convert Trim Box Fin to Tuttle?

Is everybody ready for a laugh? I have an expensive carbon Trim box fin that I will never use again. Can I cut and grind that thing down to fit in a tuttle box? It looks like it may work. I would need to add one new nut, and since when the fin is flush on the bottom surface on the board, it won't hit the end of the tuttle box, I'll need a longer bolt. Has anyone ever done this?

I know that some have ground away most of the root and cast a new root using a fin box. But alignment seems difficult.
Lanee is offline   Reply With Quote