Wood Ding Repair
I have a F160 and have read about the various ways to repair a board, but here is the issue:
The ding (less than 1 cm on the deck) was apparently caused by a knot in the uphaul or?
The ding is no more than 3mm deep.
I tested the ding with soapy water & it bubbles when the board is hot with the plug closed.
Is there a way to seal this up without going through the "layer of fiberglass" routine or "a glob of ding stick".
A lump of clear epoxy possibly?
Cut out the damaged wood and fill with epoxy (1.5 cm diameter)? The area is so small, I hate to over do it.
Thanks for any advice.
Formula 160; iSonic 111; HiFly Move 105; Tiga 263; '85 Mistral Superlight.
Maui Sails TR 11.0; 9.2; 8.4; 7.6; 6.6; Maui Sails Switch 6.0; 5.2; Maui Sails Global 4.5; 4.0.