View Single Post
Old 24th September 2012, 10:47 PM   #19
Unregistered
Guest
 
Posts: n/a
Default

I have managed to combine these two techniques. First you insert the mast into the bottom cam and bypass the next two cam by sliding the mast over the cams. Just like somebody said earlier that bottom cam can't be popped on after fully downhauled. Then check that top is properly in socket and start downhauling. In some point the mast will be bending just enough to easily pop on the middle cam (might take couple of times to figure the right amount of downhaul). Then continue until the upmost cam can be easily popped on and after that downhaul fully. So you have to pause downhauling two times and stand up to pop the cams if you get familiar with this technique. Not too hard a job and mast will thank you.
  Reply With Quote