View Single Post
Old 19th January 2014, 02:16 AM   #7
rww
Member
 
Join Date: Dec 2011
Location: Boreen Point, Queensland, Australia
Posts: 46
Default

Thanks again Roger

The clearance on the tip is tight, but it does just get through. I do have an issue on one side with the alignment of the holes to attach the cover plate that clamps the side plate in place and did think that this may be causing a problem. It does cause some misalignment of the side plate, but it doesn't seem to be binding. Anyway, as well as working the board up and down, I have removed everything and reassembled with everything aligned as best I can, and am going to try again on the water this afternoon if I get some wind. It does seem a bit freer on land. Here's hoping!

Russell
__________________
iSonic 76,107 Phantom 295L
NP RS Slalom 5.5, 6.2, 7.0, 7.8

Last edited by rww; 19th January 2014 at 07:12 AM.
rww is offline   Reply With Quote