damage of finish

rob jurriens · 22nd September 2007, 01:28 AM

Hello

Due to an impact of a sharp object (hidden stone?) a bit of the white skin/finish on the rail of my iSonic has been damaged ('broken off'). Can this be repaired and how?

Roger · 22nd September 2007, 06:16 AM

Hi Rob,
If it's just the paint/colorcoat that's damaged, get a spray can of white epoxy enamel paint that matches the white of your board (Here's a link, but it does not list the Pantone of the white used on your board)
http://www.star-board.com/2008/pages...asst_color.php

Mask off the damaged area and sand it slightly to remove anything loose. Give it a couple of light coats of paint and then lightly sand it back for a nice looking repair.
If your damaged area is greater, check out the "Damage Repair" pages at this link:
http://www.star-board.com/2008/pages...sst_repair.php
Hope this helps,

22nd September 2007, 01:28 AM	#1
rob jurriens New Member Join Date: Aug 2006 Posts: 3	damage of finish Hello Due to an impact of a sharp object (hidden stone?) a bit of the white skin/finish on the rail of my iSonic has been damaged ('broken off'). Can this be repaired and how?

22nd September 2007, 06:16 AM	#2
Roger Dream Team - School Guru Join Date: Aug 2006 Posts: 2,060	Hi Rob, If it's just the paint/colorcoat that's damaged, get a spray can of white epoxy enamel paint that matches the white of your board (Here's a link, but it does not list the Pantone of the white used on your board) http://www.star-board.com/2008/pages...asst_color.php Mask off the damaged area and sand it slightly to remove anything loose. Give it a couple of light coats of paint and then lightly sand it back for a nice looking repair. If your damaged area is greater, check out the "Damage Repair" pages at this link: http://www.star-board.com/2008/pages...sst_repair.php Hope this helps, Last edited by Roger; 22nd September 2007 at 08:09 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode