Go Back   Starboard Forums > Free Forum

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 21st October 2006, 09:27 PM   #21
Roger
Dream Team - School Guru
 
Join Date: Aug 2006
Posts: 2,110
Default RE: Help - Water in the hole!

Hi Greenroom,
I think having the board level is about the best you can do.
Maybe incline it slightly nose down so the nose is not significantly higher than the vent fitting.
The water vapor is giong to "flow" toward the lowest pressure area and that should be at the vent fitting.
As far as the O'ring damage, that's what happens to O'rings when you "squash" them flat. Not what they were designed to do at all.
Maybe don't tighten the plug so tight so you don't "squash" the O'ring
so much that it cracks or splits.
Here's a link to how an O'ring is supposed to be used as a static face seal:
http://www.allorings.com/gland_static_axial.htm
Since we are using a screw thread in the middle to apply the compression to the O'ring, the groove would need to be up inside the head of the plug.
After market plugs with the correct thread size would be wonderful, but I've never been able to find one.
Hope this helps,
Roger is offline   Reply With Quote
 

Bookmarks

Tags
None

Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +7. The time now is 11:20 PM.