|20th August 2013, 04:04 PM||#1|
Footstraps Futura 2013
Hello, how can I tighten the straps? After 5 minutes they are loose again. I use K9...and I´m scared, the screw breaks off.
|20th August 2013, 09:49 PM||#2|
Dream Team - School Guru
Join Date: Aug 2006
Did you "pre-tap" your foot strap inserts with a 6mm x 28mm foot strap screw, then lubricate the 7 mm x 32mm foot strap screws with a bar of bath soap so you can get the 7mm screws really tight without breaking the off the head of the screws or destroying/loosening the FS inserts.?
Are you using the oval toothed washers on the top side of the foot strap (opposite the spikes in the K9
If you have done these two steps, you normally only need to tighten the foot strap initially, and then snug them up after your first session on the water.
They will stay tight almost for the life of your board.
Hope this helps,
Last edited by Roger; 21st August 2013 at 12:18 AM.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Futura 131 Carbon Model 2013||Unregistered||Free Forum||4||28th February 2013 11:33 AM|
|futura or isonic 2013||Unregistered||Free Forum||3||19th January 2013 10:18 AM|
|Futura 131 vs 141 2013||Unregistered||Free Forum||3||16th December 2012 02:06 PM|
|Stock Footstraps of IS and Futura||howieP||Free Forum||1||19th September 2012 08:22 PM|
|Futura Product description 2013||brozy||Ask Our Team||2||18th August 2012 04:54 AM|