Old 24th October 2010, 09:30 PM   #1
Frederic
Member
 
Join Date: Aug 2006
Posts: 44
Default Slot box availabity

Hello,

I just want to know if there will be availability to get some slot boxes in order to replace FCS boxes of the former quads 2010.

Thanks
Frédéric
Frederic is offline   Reply With Quote
Old 25th October 2010, 02:01 AM   #2
Ola_H
TEAM
 
Join Date: Aug 2006
Posts: 1,191
Default

Technically I think your distributor can order them from Starboard. If you're used to doing repairs, it should be a rather simple operation. The boxes come pre fabricated in a hard foam block. So you need to route out a rectangular hole and then cut the foam until you reach the top laminate. WHen the boxes are installed from scratch you put them right through the board, but when retrofitting I would keep the top laminate intact.

Making the box fit nicely with the top laminate shape will require some measuring and careful sanding, but probably you can do it quite roughly and fill the cavity with expanding pu foam when mounting the box. Just make sure the foam doesn't push the box out of the board. when it expands. You don't need anything else than epoxy with some micro balloons in it for the mounting (ie no need for fiber). The upper surface of the box consists of some fibre layers and it's important that it comes out flush with the bottom (or a tiny weenie bit below). Then just smooth out with some filler, sand and put a layer of thin fibreglass over it all. I reckon it's a few hours work, but cut up in many short sessions.

But first, ask your dealer to as your distributor to order. It might take some time. While you're at it you could do the front boxes too and then enjoy the full tunability of the IQ system.

My local custom builder will start making his own slot boxes soon, so if your dealer hesitates, post here again and I can see what I can do about a set of custom boxes.
Ola_H is offline   Reply With Quote
Old 25th October 2010, 04:09 AM   #3
Frederic
Member
 
Join Date: Aug 2006
Posts: 44
Default

Thanks for your reply, but don't worry, I will ask to a local shaper who repair all boards to do it. So, it will be very well made.
I have already the quad IQ 77, perfect board, and I have the quad 66, 2010, which is with FCS and mini tuttle.
Ok I can change the FCS boxes but do you think it worth to replace the mini tuttle ? My quad 66 is now mini tuttle13 cm drake front fins and 11cm FCS rear fins equiped. In the moment, you have not the equivalent of this small board in Quad or Evo and I don't think the kode 68 will fit my conditions here in south france. SO I want to keep it, it 's an amazing small board (5.5 kg wood carbon).

I will ask to my dealer.
Thanks
Fred
Frederic is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
FCS and Slot Box -> compatible ? helga Free Forum 2 3rd August 2010 01:13 AM
Slot Box Dan Free Forum 4 18th July 2010 11:47 AM
Seal centreboard slot on Start Indrek Aavisto Windsurfing School 2 15th March 2008 11:50 AM


All times are GMT +7. The time now is 02:18 PM.