Q for Ian, Taty about Is 101

[Jean-Marc]

Superidis,

All straps on the back, RS1-6.6 sail, iSonic 76 :

The stock Drake Slalom Pro 32 cm fin felt a bit harder underfoot whereas the Deboichet SL2 30 cm was a tad softer. With the mast track set at 50%, quite a few spinout deep reaching or hard pointing upwind. Set mast track back at 30% : perfect, no more spinout !

Cheers !

JM

[davide]

Originally Posted by Ken

Taty,

Thanks for your feed back. Like Mark, I have not been satisfied with the Drake fins (spin out & hard to clear). The iSonic 111 came with a 38 and 44. I like the 44 better than the 38 and am thinking that the MFC RC 40 or 42 may be the call for my 6.6 and 7.4sails, which is my primary target. If I was into slalom racing (little or non where I live), I would be thinking two fins for the one board. If I do any slalom racing, it will be figure 8.

Thanks again,

Ken

You should also look into Tectonics and Vector fins. I used Tectonics Goldwing, Falcon and Mirage and I have never been disappointed. I just ordered a Vector Rockit 32, for my CA SL52, that is also gaining a very positive reputation out there.