Old 17th September 2009, 06:27 AM   #1
viduka12
New Member
 
Join Date: Sep 2009
Posts: 1
Default phantom320

hi,
I've been playing the phantom 320 with a overdrive 8.5m sail and i found out i have problems jibing. The board takes a long time to repond to a turn??. Any advise or tips??.. Thxs
viduka12 is offline   Reply With Quote
Old 17th September 2009, 10:25 AM   #2
Roger
Dream Team - School Guru
 
Join Date: Aug 2006
Posts: 2,100
Default

Hi viduka12,
Is the centerboard up or down when you are trying to do your jibes?
If you have the center board in the down/deployed position, the board has a hard time turning around both the centerboard and the rear fin.
Try your jibes with the centerboard up (stowed inside the board).
The alternative is to learn a "sink jibe" where you move back far enough so the nose comes up pretty high and you can pivot the board around the rear fin with much less effect from the centerboard.
Also, you need to really "tip" your 8.5 m2 rig well over the side of the board to drive the board around the jibe.
The more you rake the rig out to the side, the faster your board will turn.
Hope this helps,

Last edited by Roger; 18th September 2009 at 06:01 AM.
Roger is offline   Reply With Quote
Old 17th September 2009, 09:57 PM   #3
Ken
Member
 
Join Date: Aug 2006
Location: Dallas, Texas USA
Posts: 799
Default

vidauka12,

Roger makes good points. Assuming you are talking about non planing jibes, jibing any board with a centerboard is challenging if you want to get around quicker. As the wind picks up, it becomes even more difficult.

Regardless, the "sink jibe" / "pivot jibe" is the way to go. The challenging part is that the rail on the outside of the turn (port jibe - starboard side of board) will drop and the port side will lift. This is more pronounced on narrow boards (old long boards), but it still happens a little on the wide boards.

The quickness of the jibe depends on how much you sink the tail (how far back you move). You have to bare off the wind a bit (30-45 degrees off a beam reach) before you begin your sink jibe. If you don't, the board won't turn downwind, but will instead head upwind.

Once the board begins to jibe, be ready to move quickly to keep from being tossed off. Pivot jibes can be very fast and you don't lose any gained windward advantage, you just turn on a "dime".

The same jibe can be accomplished without the daggerboard and may be a little easier because the outside rail will not drop as much as it does with the daggerboard down.

Once you figure it out, they are pretty easy to do.
Ken is offline   Reply With Quote
Old 30th March 2010, 03:34 PM   #4
kelly7898
New Member
 
Join Date: Mar 2010
Posts: 1
Default

Thank you so much for your post.
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
kelly7898 is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
details on new Phantom320 Carbon? Best of allwind race/fun compromise mcasaldaliga Free Forum 7 27th September 2009 05:14 PM


All times are GMT +7. The time now is 09:16 AM.