|4th May 2010, 04:53 PM||#1|
Join Date: Apr 2007
Formula 160 - Adhesive Advice Needed
I've recently bought a 2nd hand Starboard Formula 160. When I got the board one of the plastic protective washers that are normally stuck on the top surface of the rear of the board where the fin bolts go through was missing. I've got a replacement plastic washer from my Starboard dealer but I'm having difficulty sticking it to the board.
So far I've tried to stick it back on with the following:
- Evo Stik Timebond Contact Adhesive - the adhesive stuck to the board but not to the plastic washer.
- Superglue - It appeared to work but after the first session back on the water when I removed the fin the plastic washer dropped off.
Can anyone recommend me an adhesive that I can use that won't damage the board ?
|plastic washer adhesive|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Advice needed for Board Set iSonic 94 111 131 or 144||xbraun||Ask Our Team||4||16th February 2010 06:37 AM|
|Advice needed !||Unregistered||Free Forum||18||14th June 2008 02:53 PM|
|Advice needed||RandyP||Windsurfing School||1||12th September 2007 06:29 PM|
|Footstrap and fin advice needed for Carve 144||different||Free Forum||2||24th January 2007 07:59 PM|
|K9 antitwist in Aero 117 - advice needed||windracer||Ask Our Team||2||21st August 2006 03:59 PM|